To estimation of strategies for machining the operating surfaces of stamp tooling by means of CAM systems according to criterion of volume velocity of material removal

Puzanov Y.V., Pechenkin I.A., Bazhin A.G., Puzanov V.Y., Nekopytkin V.V., Golikov V.V.

Abstract


The paper describes the ways of developing the most sustainable control programs by means of CAM systems. Its sustainability is achieved according to the value of volume velocity of material removal. The influence of applying the proposed control programs on manufacturability and tool wear is described.

Keywords


control program, CAM-systems, volume velocity of material removal, strategies for machining, smoothing the trajectory of tool displacement

References References

Bazhin A. G. Hardware and software complex development of processing of precisely conjugated parts based on the Delcam modules / A. G. Bazhin, I. A. Pechenkin, Yu. V. Puzanov // Universology: definitions, issues and concepts [the electronic resourse] : the electronic scientific publication: proceedingsfrom the Teachers' Technical Scientific Conference (in the English language), Izhevsk, 27June 2013 y. / Kalashnikov Izhevsk State Technical University. -Electronic data (1file : 3,18Mb.).-Izhevsk, 2013. -64pp. -1 electronic disk (CD-ROM). - System requirements: Acrobat Reader 6.0 and on. - ISBN 978-5-7526-0654-0.

Delcam. - URL:http://www.delcam.ru/products/ products.htm (дата обращения: 26.10.2014).


Article Metrics

Metrics Loading ...

Metrics powered by PLOS ALM

Refbacks

  • There are currently no refbacks.


Copyright (c) 2016 Юрий Владимирович Пузанов, Иван Андреевич Печёнкин, Алексей Гертрудович Бажин, Владимир Юрьевич Пузанов, Валерий Викторович Некопыткин, Виталий Вячеславович Голиков

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.

ISSN 1813-7911