МЕТОДИКА ПРОЕКТИРОВАНИЯ ПРОФИЛЕГИБОЧНЫХ КЛЕТЕЙ

N. V. Tepin; V. P. Shenogin

Authors

N. V. Tepin Kalashnikov Izhevsk State Technical University
V. P. Shenogin Kalashnikov Izhevsk State Technical University

Keywords:

design, roll forming, stand

Abstract

It is proposed in the paper to use the method of morphological analysis to design the roll forming stand. It is shown that application of this method will significantly enlarge possibilities of the designer. The analysis of implemented designs is carried out. The progressive design of a roll forming stand is proposed.

Author Biographies

N. V. Tepin, Kalashnikov Izhevsk State Technical University

PhD in Engineering, Associate Professor

V. P. Shenogin, Kalashnikov Izhevsk State Technical University

DSc in Engineering, Professor

References

Тепин Н. В. Совершенствование технологии и оборудования для производства гнутых профилей : дис.. канд. техн. наук : 05.03.05. – Ижевск, 2006. – 173 с.

Методика расчета технологических параметров при профилировании / В. П. Шеногин, Н. В. Тепин, В. А. Храбров и др. // Заготовит. пр-ва в машиностроении (кузнеч.-штамповоч., литейн. и другие пр-ва). – 2007. – № 4. – С. 35–37.