Measurement Tolerance Design for Operational Quality Control

Authors

  • D. V. Solomakho Belorussian National Technical University, Minsk, Belorussia
  • B. V. Tsitovich Belorussian National Technical University, Minsk, Belorussia
  • S. S. Sokolovsky Belorussian National Technical University, Minsk, Belorussia

Keywords:

operational control, measurement error, reliability, tolerance

Abstract

The issues of measurement accuracy within operational control are considered. Analysis of the technical literature and standards show that there is a kind of "normative vacuum" concerning operational control. Implementing the methodology of final inspection to operational control is not correct because the objectives of final inspection and operational control do not match. Recommendations for standardization of measurement accuracy for a variety of problems solved within operational control are provided.

Author Biographies

D. V. Solomakho, Belorussian National Technical University, Minsk, Belorussia

; Belorussian National Technical University, Minsk, Belorussia

B. V. Tsitovich, Belorussian National Technical University, Minsk, Belorussia

; Belorussian National Technical University, Minsk, Belorussia

S. S. Sokolovsky, Belorussian National Technical University, Minsk, Belorussia

; Belorussian National Technical University, Minsk, Belorussia

References

Марков Н. Н., Кайнер Г. Б., Сацердотов П. А. Погрешность и выбор средств при линейных измерениях. - М. : Машиностроение, 1967. - 392 с.

Данилевич С. Б. Планирование выходного измерительного контроля качества продукции. - Новосибирск : Изд-во НГТУ, 2006. - 137 с.

Downloads

Published

15.06.2011

How to Cite

Solomakho Д. В., Tsitovich Б. В., & Sokolovsky С. С. (2011). Measurement Tolerance Design for Operational Quality Control. Vestnik IzhGTU Imeni M.T. Kalashnikova, (2), 51–54. Retrieved from https://izdat.istu.ru/index.php/vestnik/article/view/2250

Issue

No. 2 (2011)

Section

Articles